Gå til hovedinnhold

Lowrance Hook Reveal - innstilling av 2D ekkolodd


Vi fortsetter med filmer med "tips & triks" basert på spørsmål fra dere, denne gangen med basisinnstillinger av 2D-ekkolodd. 

I filmen bruker jeg innstegsmodellen Lowrance Hook Reveal, men menypunktene jeg går gjennom er ganske universale uansett merke og modell. Siden Hook Reveal ikke er særlig egnet for manuell modus og pelagisk fiske, hopper jeg over det her, dette får jeg komme tilbake til med HDS som eksempel litt senere.


Om du ikke kan se filmen her, så prøv denne direktelinken: https://youtu.be/y-qJvmGsl70

Litt skjermbilder fra turen på Mjøsa, alle fra Lowrance Hook Reveal med 50/200-HDI som ekkoloddgiver:













FishReveal fungerer også utmerket.






For de virkelig spesielt interesserte.... Jeg har også testet å bruke Airmar TM185HW på Hook Reveal. Da velges "Generisk 83/200" som ekkoloddgiver og man kan bruke 200 kHz og høy chirp av frekvensvalgene. 200kHz støttes av TM185HW, mens Lowrance sin versjon av høy chirp avviker litt fra Airmars, så sistnevnte er ikke ideelt. Jeg vil ikke anbefale noen å bruke denne kombinasjonen, dette er kun for morro skyld for å se hvordan Hook Reveal responderer på andre ekkoloddgivere.




Som du ser vises både fisk og dyprigglodd tydeligere med TM185HW, men det er mest en konsekvens av konevinkelen (25 grader) som er større enn med 50/200-HDI på høy chirp (200 kHz gir 12 graders konevinkel). 

Kommentarer

  1. Hello, it is officially stated that Reveal does not support Aimer transducers
    How do you connect TM185HW and Reveal?

    SvarSlett
    Svar
    1. Hi! As stated in the article, Airmar TM185HW is not fully compatible with Hook Reveal, and we do NOT recommend using that transducer with Hook Reveal. You can connect any xSonic-connector to Hook Rveal (and Hook2) using adapter 000-14069-001. Kind regards Erik

      Slett
    2. Thank you for your answer~ You are very professional

      Slett
  2. Originally, the 50/200 transducer with Reveal is not enough for my sea area. I need to be able to stabilize the probe at a depth of about 300~400 meters.

    SvarSlett
    Svar
    1. Hi! Hook Reveal is a good entry-level unit, but still just entry level. :) For the depths you mention I highly recommend HDS Live, as that has both more power and more advanced signal processing, both needed when operationg in deep water, ideally combined with the S5100-module and a 1000W or more transducer. Kind regards Erik

      Slett
    2. If it is matched with other high-wattage 50/200 aimer transducers, can it reach the detection depth below 300? Like B258 P319

      Slett
    3. The output of the Hook Reveal is the same with a 500W and 1000W (or more) transducer, as it is limited within the unit. The cheapest Lowrance-unit with a 1000W-output is the new Elite FS, which has the same maximum output as HDS Live has. (All HDS-generations since Gen 3 have 1000W-output) Airmar P319 is very similar to Lowrance HST-DFSBL (or 50/200-HDI), B258 has a larger element which will be more sensetive and can detect fish deeper, but the somwehat larger conengle on 258 is not ideal for really deep water. B260 is better in 200+ meters versus B258.

      Slett
  3. Hello!
    I noticed that there is a lot of information about high chirp but no one talks about how it behaves when you use low chirp at depths greater than 100m. You also did screenshoots at 200m + on high chirp but nothing in low. Is it possible to target fish deeper if you use low chirp vs high chirp? Thank you?

    SvarSlett
    Svar
    1. Hi. As a general recommendation, use 200kHz or high chirp as deep as it gives good returns. The reason for this is the much larger coneangle on 50kHz (or low chirp) with Lowrance-transducers. Yes, 50/ low can penetrate even deeper than 200/ high, but with a 35+ degrees coneangle and large depths you basically get a flat bottom line with litle structure shown, and any fish you see are hard to relate to where the boat is due to the wide conenagle. But to answer your question, yes using 50/ low will enable you to see fish even deeper than 200/ high, the problem is that you have no idea where those fish really are versus where you are. :) Kind regards Erik

      Slett

Legg inn en kommentar

Populære innlegg

The perfect settings for Lowrance? A guide on how to set up your 2D-sonar part I.

Perhaps the most repeated question in Facebookgroups and forums regarding marine electronics: "What are the best settings?" The bad news is that there is no uniform answer to that. The good news is that you can adjust settings according to conditions if you have a little knowledge as to what settings you should tweak and why. Here is part 1 of our guide to get the most out of your unit in regards to settings.

What is the difference between HDS Carbon and HDS Live?

Here we go again, a new generation of the Lowrance HDS. And with that Facebook and the different forums are flooded with questions referring to the difference between the new and the old. So what is the difference between Lowrance HDS Live and HDS Carbon?

Lowrance Elite Ti2 versus Elite FS

  When Lowrance launches a new mid-range unit, it is a big deal. Forums and Facebookgroups light up with questions on the new stuff, differences towards the old stuff and questions on compatibility. As usual, we in Team Colibri will try our best to sort that out, both on a technical level and with a more practical in-your-boat approach.

What is the difference between Lowrance HDS Live and Elite Ti2?

Lowrance as a brand of marine electronis is well known to all anglers, but the differences within their range of different models seem to cause quite a few questions out there. Here we will try to outline the difference between Lowrance HDS Live (top end) and Lowrance Elite Ti2 (middle range). Lowrance Elite Ti2 vs Lowrance HDS Live (photo; lowrance.com) As usual, we will start with the tech and then try to translate those technical aspects to practical differences while out on the water. Hardware - housing, screen and connections. The screen and housing on Elite Ti2 is the same as on the previous Elite Ti, and again more or less the same as on HDS Gen 2 Touch. (The memorycard-door and mounting-bracket is different from HDS Gen 2 Touch.) This is by no means new stuff, and compared to the more advanced housing and screen on HDS Live, Elite Ti2 is starting to show its relative age. However, with that in mind it is worth noting that when looking at the competition, several of

Lowrance Hook 2 versus Lowrance Hook Reveal

You have to hand it to Lowrance when it comes to the name of their new entry-level line of sonar and chartplotters. We all want to hook up, and what better way to do that then by having our marine electronics reveal to us where the fish are?